EHEIM 3614 User Manual

Diese Angaben sind Richtwerte für geschlossene Aqua-
rien bei einer Wassertemperatur bis 26°C.
Garantie: 3 Jahre
N
icht auf Glasschäden, unsachgemäße Behandlung und
Öffnen des Gerätes.
Im Störungsfall bitte an Ihren Fachhändler wenden –
o
der www.eheim.com
IMPORTANT SAFETY INSTRUCTIONS
WARNING – To guard against injury, basic safety
precautions should be observed, including the follwing.
a) READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
b) DANGER – To avoid possible electric shock,
special care should be taken since water is
employed in the use of aquarium equipment. For
each of the following situations, do not attempt
repairs by yourself; return the appliance to an
authorized service facility for service or discard
the appliance.
1) If the appliance falls into the water,
DON’T
reach for it! First unplug it and then retrieve it. If
electrical components of the appliance get wet,
unplug the appliance immediately. (Non immersi-
ble equipment only)
2) If the appliance shows any sign of abnormal
water leakage, immediately unplug it from the
power source. (Immersible equipment only).
3) Carefully examine the appliance after instal-
lation. It should not be plugged in if there is wa-
ter on parts not intended to be wet.
4) Do not operate any appliance if it has a dama-
ged cord or plug, or if it is malfunctioning or has
been dropped or damaged in any manner.
5) To avoid the possibility of the appliance plug
or receptacle getting wet, position aquarium
stand and tank to one side of a wallmounted
receptacle to prevent water from dripping onto
the receptacle or plug.
A ”drip-loop”, shown in the figure “C”, should be
arranged by the user for each cord connecting an
aquarium appliance to a receptacle. The ”drip-
loop” is that part of the cord below the level of the
receptacle, or the connector if an extension cord
is used, to prevent water traveling along the cord
and coming in contact with the receptacle. If the
plug or socket does get wet,
DON’T unplug the
cord. Disconnect the fuse or circuit breaker that sup-
plies power to the appliance. Then unplug and exa-
Thermostatic aquarium heater
Kenndaten (siehe Tabelle Seite 2)
Temperatureinstellung
B
Netzstecker ziehen. Durch Drehen des Einstellringes
a
die gewünschte Temperatur einstellen. Netzstecker
einstecken. „Rotes Licht“
f
= Heizbetrieb.
Nachjustierung
Wenn die Einstellskala nach 1-2 Tagen nicht mit der Was-
sertemperatur übereinstimmt, können Sie wie folgt vorge-
hen, um Ihren Heizer neu einzustellen:
•
Netzstecker ziehen
•
Wassertemperatur mit genauem Thermometer messen
•
M
arkierungspfeil (rot)
b
a
uf die gemessene Wasser-
t
emperatur drehen
•
M
it der Einstellskala (blau)
a
d
ie
g
ewünschte Beckentemperatur einstellen. • Netzstecker
e
instecken.

EHEIM 3614 Specifications

General

Brand	EHEIM
Model	3614
Category	Heater
Language	English