16
English
5. Assembly
Location
‧ Avoid direct sunlight, and not too much daylight!
‧ Keep the aquarium away from heat sources.
‧ Keep the aquarium away from electrical equipment.
‧ Be aware of any nearby mains connections.
CAUTION! Material damage.
▶ Ensure that the surface is level and stable.
▶ Be mindful of the oor load provided by the entire weight.
Setting up and aligning the base cabinet (⌦A)
1. Place the base cabinet in the desired position.
2. Align the base cabinet horizontally using a spirit level.
A stand can be used for horizontal alignment. Ensure that the stand rests fully on the surface.
Setting up the aquarium (⌦C)
Danger! Personal injury or material damage.
The aquarium must not be transported or carried when in its lled state.
Caution! Material damage.
No foreign bodies, mats or bases must be placed between the aquarium and base cabinet.
▶ Thoroughly clean the top side of the base cabinet and the lower side of the aquarium base.
▶ Remove any foreign bodies, mats or bases.
1. Place the empty aquarium on the base cabinet. Ensure that the connections lie in the section of the
base cabinet’s top side.
Adjusting/removing the doors
‧ You can readjust the doors (⌦D).
‧ The doors can be quickly removed/attached via the quick-release function (⌦E).
6. Commissioning
Installing drains (⌦F)
‧ The drain is factory-installed.
‧ Types 230, 330 and 430 have a drain. Type 530 has two drains.
‧ Hint: Install an EHEIM double tap between the drainpipe and the lter to simplify maintenance.
‧ Check whether the drain(s)
are
secure.
‧ Place the lter in the base cabinet.
‧ Mount the hose of your lter on the drain neck. Please observe the operating manual of your lter.
To Next Page
Loading...
Need help?
General
