English
11
‧ A hot appliance must never be placed on
heat-sensitive surfaces!
‧ Repairs must only be carried out by an
EHEIM service centre.
‧ The mains cable of this appliance cannot be
replaced. If the cable is damaged, the appli
-
ance must be scrapped.
‧ Only carry out the work described in these
instructions.
‧ Only use original spare parts and accessories
for the appliance.
‧ We recommend protecting all electrical
aquarium appliances via a residual current
protective device with a rated residual current
of 30 mA maximum.
‧ If they are not being used, always disconnect
all devices in the aquarium from the power
supply before you install/remove any parts
and before all cleaning and maintenance
work.
‧ Protect the mains socket and
mains plug against moisture
and wetness. A drip loop
must be formed with the
mains cable.
This prevents any water running along the
cable to the mains socket, which would result
in a short-circuit.
‧ The electrical data of the appliance must
match the data of the power mains. This data
is found on the type plate, the packaging and
in these instructions.
‧
‧ Danger of burning! The appliance is very hot
during and directly after operation. Never
touch hot parts or the heating zone
d
!
4. Commissioning
Installing the heater (⌦A)
1. Remove the transportation protection
e
.
2. Connect the suction device
b
to the suction device mount
a
.
3. Connect the suction device mount to the heater (not in the area
of the heating zone
d
and the control light
c
).
4. Attach the appliance below water level on the inside of your
aquarium (⌦C). Take the minimum water level and maximum
immersion depth into account.
To Next Page
Loading...
Need help?
General
