What to do if my EIBENSTOCK Drill motor cuts off?
If the EIBENSTOCK Drill motor cuts off because the tool overheats and the overload protection of the motor has activated, discharge the tool and restart it by pressing the switch. If the tool stops, ensure you are guiding it in a straight manner.
How to troubleshoot an EIBENSTOCK Drill that does not work?
If your EIBENSTOCK Drill isn't working, first, plug in another electric appliance to ensure the mains current supply is working. If that's not the issue, have an electric specialist check the line cord, plug, and switch for damage and replace if necessary. Also, ensure the PRCD-switch is on by pressing RESET.
Why is the drilling speed of my EIBENSTOCK Drill too slow?
There might be a few reasons why your EIBENSTOCK Drill speed is too slow. It could be due to high water pressure/water flow, so regulate the water quantity. Alternatively, the drill bit might be damaged or blunt; check and replace or sharpen it as needed with a sharpening block while using the flush. In some cases, it could be due to a damaged gearbox, which would require repair by an authorized service workshop.
What to do if EIBENSTOCK Drill motor runs, but the drill bit does not rotate?
If the motor of your EIBENSTOCK Drill is running but the drill bit isn't rotating, the gearbox may be damaged. You should have the tool repaired by an authorised service workshop.
What causes too much backlash in my EIBENSTOCK Drill system?
If your EIBENSTOCK Drill system has too much backlash, it's likely due to excessive backlash in the guidance. Try to readjust the guidance.
General| Brand | EIBENSTOCK |
|---|---|
| Model | DB 200 GR |
| Category | Drill |
| Language | English |
To Next Page
