Need help?Do you have a question about the Eico 753 and is the answer not in the manual?
General| Tuning Method | Manual |
|---|---|
| Power Supply | Internal |
| Type | Transceiver |
| Modulation Modes | CW |
| Power Input | 117 VAC, 60 Hz |
| Input Impedance | 50 ohms |
| Output Impedance | 50 ohms |
| Tubes | 12AX7, 12AT7, 6AQ5 |
Overview of the transceiver's key capabilities and technical specifications.
Guidance for setting up and connecting the transceiver for operation.
Instructions for safely removing the transceiver from its packaging.
Requirements for adequate airflow to prevent overheating.
Guidelines for connecting suitable antennas and connector types.
Details on using external relay terminals for accessory control.
Instructions for installing the transceiver in a mobile environment.
Guidance on connecting a speaker for mobile operation.
Instructions for connecting a microphone to the transceiver.
Detailed procedures for setting up and tuning the transceiver for SSB mode.
Steps to align the receiver for optimal SSB reception and performance.
Steps to align the transmitter for optimal SSB output and tuning.
Procedure for adjusting microphone gain for optimal transmit audio levels.
Explanation of the dual-ratio ball drive tuning mechanism.
How to fine-tune receiver frequency without altering transmitter frequency.
Procedures for operating the transceiver in CW mode.
Procedures for operating the transceiver in AM mode.
Explanation of the MODE switch functions in different operating modes.
Guidance on adjusting PA TUNE and PA LOAD controls for proper output.
Adjustment and effect of the CARRIER BALANCE control.
How to activate the 100kc crystal oscillator calibrator.
Use of the AF GAIN control for audio volume.
Setting the RF GAIN control for desired S-meter reading.
Procedure to set the S-meter to zero for accurate signal strength readings.
Detailed explanation of the transceiver's transmitting circuits.
Detailed explanation of the transceiver's receiving circuits.
Explanation of the Voice Operated Transmit (VOX) circuit.
General maintenance advice, including tube replacement.
Instructions for removing the transceiver's cabinet.
Comprehensive steps for aligning the transceiver's circuits.
Procedure for aligning the receiver section of the transceiver.
Steps to align the Intermediate Frequency (IF) strip of the receiver.
Steps to align the Variable Frequency Oscillator (VFO) for accurate tuning.
Procedures for aligning the transmitter section of the transceiver.
Procedure for adjusting the transceiver's crystal filter for optimal performance.
Detailed table of tube pin voltages and resistances.
List of capacitors used in the transceiver with part numbers.
List of diodes used in the transceiver with part numbers.
List of connectors and terminal boards with part numbers.
List of coils used in the transceiver with part numbers.
List of meters used in the transceiver with part numbers.
List of Printed Circuit (PC) boards with part numbers.
List of lamps used in the transceiver with part numbers.
List of parasitic traps with part numbers.
List of resistors and potentiometers with part numbers.
List of relays used in the transceiver with part numbers.
List of switches used in the transceiver with part numbers.
List of transformers used in the transceiver with part numbers.
List of terminal boards used in the transceiver with part numbers.
List of tubes and transistors with part numbers.
List of crystals used in the transceiver with part numbers.
List of crystal sockets used in the transceiver with part numbers.
List of tube sockets used in the transceiver with part numbers.
List of miscellaneous components and hardware with part numbers.
To Next Page