Eilon Engineering Ltd. RON 2501 NG Operating Manual 23
To activate
the “continuous max. display” press the MAX. + ENTER keys
simultaneously. The display will indicate “MAX.ON” and switches itself to
the “continuous max. display” mode and continuously displays the max. value
that was detected from the time that the system was switched on.
To cancel
the “continuous max. display” mode, press the two keys MAX. +
ENTER simultaneously. The display: “MAX. OF”.
The max. value will be stored in memory and can be displayed for about two
seconds whenever the user presses the max. key.
To reset the max. value, switch the system off.
When switching on, the max. value is reset automatically.
8.12 DAMPENED READINGS – IF APPLICABLE
To switch on the dampening mode, press the keys ZERO + TARE
simultaneously. The display will show AVR.ON.
To switch off the dampening mode, press both keys again. The display will
show AVR.OF.
When calibrating the system, avoid using dampening, i.e. switch off the
dampening mode.
When lifting a load from zero in dampened mode, you will have to wait a few
seconds until the display stabilizes at the correct value, but it will be
significantly quicker compared to an undampened reading.
To Next Page
Loading...
