EINHELL 34.108.20 - User Manual

Questions and Answers

J
James BarnesAug 11, 2025
Why does my EINHELL Saw operate intermittently?
- M
  Mr. Donald Richard Jr.Aug 11, 2025
  If your EINHELL Saw operates intermittently, it could be due to a loose connection, either external or internal, or a defective ON/OFF switch. In any of these cases, consult a specialist workshop for assistance.
B
brandon81Aug 19, 2025
Why is the chain/guide bar on my EINHELL Pole Saw hot?
- K
  Keith CollinsAug 19, 2025
  If the chain or guide bar of your EINHELL Pole Saw is hot, it could be due to several reasons. First, check if there is enough oil in the tank and top it up if necessary. A blocked vent in the oil tank cap can also cause this issue, so clean the cap. Additionally, clear any blockage in the oil outlet. If these steps don't resolve the problem, the chain might be blunt and needs re-sharpening or replacement. Lastly, check the chain tension, as an overtensioned chain can also lead to overheating.
J
Joanna JimenezAug 26, 2025
How to fix a dry saw chain on my EINHELL Pole Saw?
- M
  Matthew GarciaAug 26, 2025
  If your EINHELL Pole Saw chain is dry, there might be a few reasons. Start by checking the oil level in the tank and top it up if it's low. Also, the vent in the oil tank cap might be blocked, so try cleaning it. Finally, the oil outlet could be blocked, so clear it to ensure proper lubrication.
D
deborah81Sep 3, 2025
What to do if my EINHELL Pole Saw chain judders or doesn't saw properly?
- C
  Caleb JohnsonSep 3, 2025
  If your EINHELL Pole Saw chain saw judders, vibrates, or does not saw properly, several issues could be the cause. Start by checking the chain tension and adjust it if it's undertensioned. The chain might also be blunt, requiring re-sharpening or replacement. If the chain is worn, replace it. Finally, ensure the saw teeth point in the correct direction; if not, refit the chain properly.