GBGB
- 29 -
7.4 Sharpening the guard hood blade
The guard hood blade (Fig. 2/Item 14) can be-
come blunt over time. When you notice this, undo
the screw holding the guard hood blade on the
guard hood. Clamp the blade in a vise. Sharpen
the blade with a at le and make sure that the
angle of the cutting edge is not altered in the pro-
cess. File in one direction only.
7.5 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.6 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
Spare line spool Art. No.: 34.050.96
Spare cutting blade Art. No.: 34.050.82
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council oces.
9. Storage and transport
Remove the batteries. Store the equipment and
its accessories in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
equipment in its original packaging.
The equipment has an integrated wall holder (Fig.
26/Item L) to enable it to be hung on the wall.
•
Always hold the equipment with one hand on
the handle and the other hand on the additio-
nal handle. Do not carry the equipment by its
motor housing.
•
Secure the equipment against slipping if you
transport it in a vehicle.
•
As far as possible, use the original packaging
for transporting the equipment.
•
Use a transport guard for metal blades during
transport and storage.
10. Faults
The equipment does not work:
Check that the battery is charged and whether
the charging unit is working. If the equipment will
not work in spite of the voltage supply being OK,
please send it to the customer service address
below.
Anl_Agillo_36_255_BL_SPK13.indb 29Anl_Agillo_36_255_BL_SPK13.indb 29 16.08.2021 12:06:1016.08.2021 12:06:10
To Next Page
Loading...
