GB
- 20 -
10. Possible causes of failure
Fault Cause Remedy
Device not working. - No voltage present at the tool.
- Tool overheated (status LED (11)
fl ashes on and off for 10 seconds).
- Battery not charged.
- Battery not connected properly.
- Allow the device to cool down.
Motor running but
no water being de-
livered.
- Inlet nozzles blocked.
- Water tank empty.
- Clean the inlet nozzles. (See 7.1.3)
- Fill up the water tank.
9. Storage
Store the equipment and accessories out of
children’s reach in a dark and dry place at above
freezing temperature. The ideal storage tempera-
ture is between 5 and 30 °C. Store the electric tool
in its original packaging.
Anl_CLEANEXXO_SPK13.indb 20Anl_CLEANEXXO_SPK13.indb 20 15.06.2023 11:54:3915.06.2023 11:54:39
To Next Page
Loading...