EN
- 11 -
•
Make sure that the air vents are free of dirt.
•
Do not try to use the equipment to cut grass
which is not growing on the ground; for
example, do not try to cut grass growing on
walls or stones, etc.
•
The person operating the string trimmer is
liable for any damages sustained by third
parties within the equipment’s working radius
as a result of its use.
•
Do not cross roads or gravel paths with the
equipment switched on.
•
When you are not using the equipment, keep
it in a dry place out of the reach of children.
•
Use the equipment only in the way described
in these operating instructions and always
hold it perpendicular to the ground. Every
other position is dangerous.
•
Check at regular intervals that the screws are
properly tightened.
•
The area to be cut must always be kept
cleared of cables and other objects.
•
If the equipment has to be lifted for
transporting, be sure to switch off the motor
first and wait for the cutting unit to come to a
standstill. Each time you leave the equipment,
switch off the motor.
•
Under no circumstances are you to cut
against hard objects during use. This is
imperative to prevent injury to yourself and
damage to the equipment.
•
Use only original replacement parts for
repairs.
•
Before starting up the equipment, and after
any collision, check the equipment for signs
of wear or damage and have any necessary
repairs carried out.
•
Always keep your hands and feet away from
the cutting unit, especially when switching the
motor on.
•
Pull out the power plug before checking,
cleaning or doing any work on the equipment
and when it is not being used.
•
Acquaint yourself with the controls and how to
use the tool.
•
Stop using the equipment when there are
people – particularly children – or pets nearby.
•
Never use the machine if protective
equipment is damaged or missing.
•
Never mount metal cutting elements.
•
Electrically powered trimmers should be
repaired only by authorized persons.
•
Use only spare parts and accessories which
are recommended by the manufacturer.
•
Before use, you must check the power cable
and extension cable for signs of damage and
wear.
•
Keep the power cable and the extension
cable away from the cutting unit.
•
If the cable is damaged during operation, it
must be disconnected immediately from the
power source. Do not use the machine if the
power cable is damaged or worn.
•
Never connect a damaged power cable to
the power source or touch a damaged cable
before it has been disconnected from the
power source – damaged cables might result
in you touching active parts.
•
Keep extension cables away from dangerous
moving parts in order to prevent damage to
cables that might result in you touching active
parts.
•
The machine should be supplied with a trip
current of no more than 30mA via a residual
current pro-tective device (RCD).
Important: The cutting unit continues to run
for a few seconds after the motor is switched
off .
The cutting unit continues to rotate!
Extension Cord – Make sure your extension cord
is in good condition. When using an extension
cord, be sure to use one heavy enough to carry
the current your product will draw. An undersized
extension cord will cause a drop in line voltage
resulting in loss of power and overheating.
Avoid Unintentional Starting – Don’t carry
plugged-in appliance with finger on switch. Be
sure switch is off when plugging in.
Don’t Abuse Cord – Never carry appliance by
cord or yank it to disconnect from receptacle.
Keep cord from heat, oil, and sharp edges.
Don’t grasp the exposed cutting blades or cutting
edges when picking up or holding the appliance.
(For grass shears and similar appliances only.)
Anl_GC_ET_4530_SPK7_USA.indb 11Anl_GC_ET_4530_SPK7_USA.indb 11 21.12.2022 08:57:2421.12.2022 08:57:24
To Next Page
Loading...
Need help?
General
Weight and Dimensions
