Need help?Do you have a question about the EK-Quantum Kinetic TBE D5 PWM and is the answer not in the manual?
General| Brand | EK-Quantum |
|---|---|
| Model | Kinetic TBE D5 PWM |
| Category | Water Pump |
| Language | English |
Install the EK-Quantum Kinetic TBE D5 onto the EK-D5 PWM G2 Motor, ensuring the O-ring gasket is seated correctly. Rotate motor if required.
Secure the EK-D5 PWM G2 Motor onto the EK-Quantum Kinetic TBE D5 using the provided Locking Ring.
Use the alternative soft rubber damper to reduce vibrations; ensure pyramids face upwards. Recommended for vertical installation.
Replace the anticyclone with the EK-HD Tube to resolve air bleeding or vortexing issues. Insert O-ring and tube into the center hole.
Ensure correct gasket placement and fitting installation sequence. Use compatible fittings (G1/4 thread, <5mm length) to avoid damage.
Find an appropriate mounting position. Drill mounting holes if needed, using the enclosed sticker for precise marking.
Attach the pump holder to the computer chassis using M4x10 screws and PVC washers, secured with the 2.5mm Allen key.
Insert the rubber damper into the holder, then the pump/reservoir assembly. Secure with M3x12 screws.
Identify INLET and OUTLET ports. Use compatible fittings (G1/4, <5mm thread). Block unused ports with enclosed G1/4 Plugs.
Connect the 3-pin D-RGB LED to the motherboard's DRGB HEADER (+5V, Digital, Ground). Ensure correct pin alignment to prevent damage.
To Next Page