Need help?Do you have a question about the ELECREALM M.NT68676.2A and is the answer not in the manual?
General| Brand | ELECREALM |
|---|---|
| Model | M.NT68676.2A |
| Category | Controller |
| Language | English |
Details the jumper setting for 3.3V output on the controller board.
Illustrates the jumper configuration for 5V output voltage.
Shows the jumper setting for 12V output voltage.
Initial step to confirm LCD display by showing a colored image.
Press the ON/OFF button to shut down the controller board.
Hold down the MENU button while performing the next action.
Press the ON/OFF button again to power on the device.
Release ON/OFF button first, then the MENU button.
Use the LEFT button to move the cursor on the screen.
Navigate to 'Lvds Map' using the MENU button.
Change 'Lvds Map' value to 1 and press AUTO twice.
Lists the necessary hardware: VGA Cable, Parallel Programmer, Parallel Cable.
Install the DriverLINX Port I/O Driver program on your PC.
Connect the necessary cables for the firmware upgrade process.
Launch the Easy Writer executable file to begin the installation.
Launch EasyWriter software and configure settings like Auto detect.
Confirm software settings and complete the configuration process.
Navigate to Options and disable the FE2P Mode Enable setting.
Select the appropriate firmware (.bin) file for loading into the software.
Initiate the firmware burning process by pressing the AUTO button.
Confirm that the firmware upgrading process has finished successfully.
Troubleshooting steps for failed firmware upgrades, including re-burning.
Details the power adapter specifications for the controller board.
Explains LCD voltage requirements and jumper settings.
Procedure to verify correct connections before powering on.
To Next Page