Electac MT800 - Page 5

)64
v
If
the Mig torch
attachment is
used,
it
should be
clipped onto the
Mig nozzle
approximately 25mm
from
the end
of the torch
shroud. If weld
porosity
is
experienced,
move
the attachment
further
up
the torch
shroud.
When
welding in
combined
situations,
the attachments
can
be
pushed
either 90
degrees
to
the
left
or
the right
to
avoid
porosity.
It is
usually
best
to fix
the
20mm
diameter
extraction
hose
to the
Mig torch lead
with
tape
allowing
a small loop
where
the extraction
hose
goes
over the
operators
hand.
When
using a
Mig torch
with built
in extraction,
follow
the
torch manufacturers
instructions,
after
connecting
the
extraction
hose
to
the spigot
adjacent
to the Euro
connector
ofthe torch.