31
NOTE:To re-assemble the door follow the opposite rules
of removal.
Please pay attention that the recessed forms should be
positioned properly on the hinge counterparts as shown on
2nd gure.
Cleaning of Gas Cooker - Hob Part
1. Lift up the pan supports, caps and crowns of hob burners.
2. Wipe and clean the back panel with a soapy cloth.
3. Wash the caps and crowns of hob burners and rinse them.
Do not leave them wet, immediately dry them with paper
cloth.
4. After cleaning, make sure that you re-assemble the parts
correctly.
5. Do not clean any part of the hob with wire wool. It causes
the surface to be scratched.
6. The pan support top surfaces may, in time be scratched
due to usage. In this case, these parts may rust which is
not a production fault.
7. During cleaning of the hob plate, make sure that no water
ows inside the burner cups, as this may block the injectors.
To Next Page
Loading...
