ELECTROCOMPANIET ECD 2 Firmware Update Instructions

ECD 2
Low Level Firmware Update Instructions
The low level firmware handles basic
The update
should be done by
Firmware updates done by unauthorized people/ end
and may result in damaging the unit and loss of warranty.
Main Changes with new
low level firmware
-
Waking from standby now works every time. It no longer occasionally
hangs on the ‘E’ logo.
-
The dim level is remembered between power cycles and standby.
- The version n
umber can now be retrieved through the home link protocol.
To update the low level
firmware,
1. Turn OFF ECD 2
by
2. Connect a
Windows
back panel of
ECD 2
not work).
If there is no serial
In most cases
it is necessary to install driver
converter before
the upgrade procedure. Due to the
different USB
to RS
cannot
support the driver
support line of your particular cable manufacturer.
3. Unzip the file "
ecd2sw mainboard.zip
PC.
2 new directories
will be built:
4. Turn ON ECD 2.
–
Low Level Firmware Update Instructions
The low level firmware handles basic
functionality on the main board
should be done by
authorized Electrocompaniet-
service points
Firmware updates done by unauthorized people/ end
users are on their own risk
and may result in damaging the unit and loss of warranty.
low level firmware
:
Waking from standby now works every time. It no longer occasionally
hangs on the ‘E’ logo.
The dim level is remembered between power cycles and standby.
umber can now be retrieved through the home link protocol.
firmware,
please proceed as follows:
by
using the main power switch.
Windows
- PC with a RS-
232 serial port to the RS
ECD 2
. Use a straight through cable (a null-
modem cable will
If there is no serial
ports on your PC use a USB to RS-
232 converter.
it is necessary to install driver
-
software for the
the upgrade procedure. Due to the
enormous number
to RS
-232 converters
and OS versions, Electrocompaniet
support the driver
installation p
rocess. Please use the manual and
support line of your particular cable manufacturer.
ecd2sw mainboard.zip
" to
the root directory “C:
will be built:
“C:\stk500” and “C:\
ecd2sw mainboard
Low Level Firmware Update Instructions
functionality on the main board
.
service points
only!
users are on their own risk
Waking from standby now works every time. It no longer occasionally
The dim level is remembered between power cycles and standby.
umber can now be retrieved through the home link protocol.
232 serial port to the RS
-232 port on the
modem cable will
232 converter.
software for the
USB to RS-232
enormous number
of
and OS versions, Electrocompaniet
rocess. Please use the manual and
the root directory “C:
\” on your
ecd2sw mainboard
”. **

ELECTROCOMPANIET ECD 2 Specifications

General

Category	Media Converter
Manufacturer	ELECTROCOMPANIET
Model	ECD 2
Digital Outputs	1 x Coaxial, 1 x Optical
DAC Resolution	24-bit/192kHz
Supported Formats	PCM
Weight	10 kg
Type	DAC
Analog Outputs	XLR, RCA