8
Reversing the Door
6 Loose screws used to fix the middle
hinge and remove middle hinge. Then
remove the lower door.
7 Place the lower door on a smooth
surface with its panel upwards.
Change the handle to the right side
according to step 5. Loose screws
⑦. Detach part ⑥ and part ⑤. Turn
part ⑤ by 180 degrees and then
install part ⑤ and part ⑥ to the
corresponding position on the left
side together with the screws.
Doorholder
Stopblock
Self-tapping
screws
1
2
Handle Covers
Special Self-
tapping Screws
Handle
Screw Hole
Covers
1
2
3
4
5
6
7
8
1
2
3
5
6
7
4
8 Change screw hole covers on middle
cover plate from left to right (as
shown in figure below).
5 Remove the upper door and place
it on a smooth surface with its panel
upwards. Lever part ① and part ④,
then loose screws ②, as shown in
the picture. Change handle ③ to
the right side, then install screws ②,
part ① and part ④ in turn. Loose
screws ⑦, detach part ⑥ and part
⑤, then install part ⑤ and another
part ⑥ (in the plastic bag) to the left
side with screws ⑦. Put part ⑥, just
detached, back into the plastic bag.
1
2
1
2
3
Handle Covers
1
Special Self-tap ping
Screws
2
Handle
3
Screw Hole Covers
4
Door Holder
5
Stop Block
6
Self-tapping Screws
7
1
2
3
4
5
6
7
To Next Page
Loading...
