www.electrolux.com ENGLISH 20
DURING FIRST MOUNTING OF YOUR REFRIGERATOR
* Lay your refrigerator with a small angle to its back after you re-moved the pad
lower
*(1) First, set the height of right stationary foot (the hinge side) untilthe distance
between the front side and the ground were 3-3.5cm after that put the refrigerator
on a at and though ground.
*(2) Make sure the ground is rm and at otherwise product might stay diago-
nally unsecure which might cause opening/ levelling issues at doors.
*(3) After all set other stationary foot (left) until the refrigerator became balanced.
*(4) This tilted back position will allow the doors to self close and seal properly.
IMPORTANT !
THE FIRST INSTALLATION OF THE APPLIANCE
AND SETTING THE STATIONARY FOOTS
Hinge
Turning this way will lift the
product up
Turning this way will lift the
product down
3-3, 5 cm
To Next Page