- 11 -
This appliance complies with the following E.E.C. directives:
– 73/23/EEC, dated 19.02.1973 – low-voltage directive.
– 89/336/EEC, dated 03.05.1989 (incl. amendment
– 92/31/EEC) – directive on electromagnetic compatibility.
Indicator for the selected programme
flashes:
The display shows error code , 10.
(Problems with the water supply).
• Is the water tap turned on?
• Is the filter inside the inlet hose blocked?
• Is the water inlet hose kinked or squashed?
• Are the filters clogged?
Fault Check
Indicator for the selected programme
flashes:
The display shows error code , 20.
(Problems with water drainage).
• Is the spigot blocked?
• Is the water drain hose kinked or squashed?
• Are the filters clogged?
In the event of a fault
With help of the error code on the display, it’s possible that you can solve the problem yourself. When the problem is
solved, press in the button for the disrupted programme and the programme continues.
For other error codes on the display ( , followed by a numbers):
• Interrupt the dishwashing cycle.
• Switch the dishwasher off.
• Select the relevant programme again.
If the problem occurs again, contact your local service centre, stating the error code.
To Next Page
Loading...
