Programme Degree of soil
Type of load
Phases in the cy‐
cle
Detergent pre-
wash / main wash
(g)
Rinse
aid
Light soiling, all
types of dish load
• Dishwash
40 °C
• Rinse
- / 15
1)
This programme offers the most efficient use of water and energy consumption for crock‐
ery and cutlery with normal soil. This is the standard programme for test institutes.
5.2 Consumption values
Programme
1)
2)
Duration (min) Energy (kWh) Water (l)
140 1.20 9.6
120 1.05 7.7
230 0.609 6.5
90 1.10 6.6
60 0.82 5.8
30 0.50 5.8
1)
The pressure and the temperature of the water, the variations of the mains supply, the
options, the quantity of dishes and the degree of soil can change the values.
2)
The values for programmes other than ECO are indicative only.
5.3 Information for test
institutes
To receive the necessary information for
conducting performance tests (e.g.
according to: EN60436 ), send an email
to:
info.test@dishwasher-production.com
In your request, include the product
number code (PNC) from the rating plate.
For any other questions regarding your
dishwasher, refer to the service book
provided with your appliance.
5.4 Before starting a
programme
Before you start the selected
programme, make sure that:
• The filters are clean and correctly
installed.
• The cap of the salt container is tight.
• The spray arms are not clogged.
• There is enough salt and rinse aid
(unless you use multi-tablets).
• The arrangement of the items in the
baskets is correct.
• The programme is suitable to the type
of load and the degree of soil.
• The correct quantity of detergent is
used.
5.5 Using a programme
1. Close the appliance door.
2. Open the water tap.
3. Press the On / Off button to activate
the appliance.
4. Press Programme button until the
indicator of the selected programme
comes on.
5. Press Start / Reset button to start the
programme.
When a programme is completed, an
intermittent acoustic signal sounds for a
few seconds.
www.electrolux.com8
To Next Page
Loading...
