Electrolux EUC1WS - Reasonably Foreseeable Improper Use; Residual Risks

12
WWAARRNNIINNGG
Extraordinary machine
maintenance operations
must only be carried out by
specialised technicians
provided with all the
appropriate personal
protection equipment (safety
shoes, gloves, glasses,
overalls, etc.), tools, utensils
and ancillary means.
Never operate the machine,
removing, modifying or
tampering with the guards,
protection or safety devices.
Before carrying out any
operation on the machine,
always consult the manual,
which gives the correct
procedures and contains
important information on
safety.
CC..66 RReeaassoonnaabbllyy ffoorreesseeeeaabbllee iimmpprrooppeerr uussee
Improper use is any use different from that specified in this
manual. During machine operation, other types of work or
activities deemed improper and that in general can involve
risks for the safety of operators and damage to the appliance
are not allowed. Reasonably foreseeable improper use
includes:
• lack of machine maintenance, cleaning and periodical
checks;
• structural changes or modifications to the operating logic;
• tampering with the guards or safety devices;
• failure to use personal protection equipment by operators,
specialised technicians and maintenance personnel;
• failure to use suitable accessories (e. g. use of unsuitable
equipment or ladders);
• keeping combustible or flammable materials, or in any
case materials not compatible with or pertinent to the work,
near the machine;
• wrong machine installation;
• placing in the machine any objects or things not compatible
with its use, or that can damage the machine, cause injury
or pollute the environment;
• climbing on the machine;
• non-compliance with the requirements for correct machine
use;
• other actions that give rise to risks not eliminable by the
Manufacturer.
WWAARRNNIINNGG
The previously described
actions are prohibited!
CC..77 RReessiidduuaall rriisskkss
The machine has several risks that were not completely
eliminated from a design standpoint or with the installation of
adequate protection devices. Nevertheless, through this
manual the Manufacturer has taken steps to inform operators
of such risks, carefully indicating the personal protection
equipment to be used by them. Sufficient spaces are provided
for during the machine installation stages in order to limit
these risks. To preserve these conditions, the areas around
the machine must always be:
• kept free of obstacles (e. g. ladders, tools, containers,
boxes, etc.);
• clean and dry;
• well lit.
For the Customer's complete information, the residual risks
remaining on the machine are indicated below: such actions
are deemed improper and therefore strictly forbidden.
RReessiidduuaall rriisskk DDeessccrriippttiioonn ooff hhaazzaarrddoouuss
ssiittuuaattiioonn
Slipping or falling The operator can slip due to water
or dirt on the floor
Catching, dragging or
crushing
Catching or dragging of the
operator or other persons in the
drive, during the machine work
phase, due to improper actions,
such as:
• placing an arm inside the
machine to remove a stuck rack
without stopping the machine
by operating an emergency
switch;
• accessing the rack handling
system without stopping the
machine by operating an
emergency switch.
Use of improper clothing with
loose parts (e.g. necklaces,
scarves, shawls, ties, etc.) or long
hair not gathered, which could get
caught up in moving parts.
Burns/abrasions (e.g.
heating elements,
cold pan, cooling
circuit plates and
pipes)
The operator deliberately or
unintentionally touches some
components inside the machine
without using protective gloves
Burns The operator deliberately or
unintentionally touches some
components inside the machine or
dishes at the outfeed without using
gloves or without allowing them to
cool.
Shearing of upper
limbs
The operator violently closes the
front panels.
Electrocution Contact with live parts during
maintenance operations carried
out with the electrical panel
powered
Falling from above The operator intervenes on the
machine using unsuitable systems
to access the upper part (e.g. rung
ladders, or climbs on it)
Crushing or injury The specialised technician may
not correctly fix the control panel
when accessing the technical
compartment. The panel could
close suddenly.