27
KK MMAACCHHIINNEE CCLLEEAANNIINNGG AANNDD MMAAIINNTTEENNAANNCCEE
KK..11 EEnndd ooff sseerrvviiccee aanndd ddaaiillyy cclleeaanniinngg
The appliance is designed to carry out an automatic cleaning
cycle to help flush out any residues and to guarantee greater
health and hygiene:
• Open the door and take out the rack containing the clean
dishes.
• Remove the flat filters “C“ and the overflow “A“ .
Close the door.
• Select the drain cycle by pressing button Drain/Self
cleaning cycle.
• The message “CLE“ will be displayed throughout the drain
cycle:
• After a few minutes, 3 beeps indicate the end of the
cleaning cycle and the message “END“ blinks on the
display:
• Switch off the dishwasher by pressing ON/OFF button.
• Switch off at the mains.
• Close the water supply tap.
• Replace the filters and the overflow.
• Unscrew the ring nuts “H“ and remove the header units “C“.
• Release the arms “F“, “I“ and “O“ from the hub, remove the
threaded plugs “L“ and “Q“.
• Carefully clean all the parts with a water jet and neutral
detergent/detersive, if necessary using a soft brush or
sponge. Do not use sharp implements to clean the nozzle
holes, which could otherwise be damaged.
• Only if the filters “M“ are present in the appliance, remove
and clean them under a water spray.
• Remove the filter “Z“ and clean away any remained food in
order to avoid blocking the draining system.
CCAAUUTTIIOONN
The rinse arms “I“ and “O“ are not
symmetrical; the rinse arm with raised
ring (“O“) should be fitted onto hub
socket.
• Upon completion of cleaning operations, replace the parts
removed previously.
KK..11..11 CClleeaanniinngg tthhee eexxtteerriioorr ssuurrffaacceess
Before carrying out any cleaning operations, turn off the
power at the mains.
CCAAUUTTIIOONN
Clean the stainless steel surfaces using
warm soapy water; never use detergents
containing abrasive substances nor steel
scrapers, common wire wool, brushes or
scrapers; rinse thoroughly using a wet
cloth and carefully wipe dry. Clean the
control panel using a soft damp cloth and
a neutral detergent if necessary. Do not
wash the appliance using direct or high-
pressure water jets.
To reduce the emission of pollutants into the environment,
clean the appliance (externally and where necessary
internally) with products having a biodegradability of over
90%).
KK..22 RReeggeenneerraattiioonn ccyyccllee
To reduce problems caused by the presence of calcareous
substances in the water supply, a water softener device has
been fitted in the rinse circuit of the dishwasher. This device
removes the calcareous substances from the feed-water,
supplying decalcified water necessary for the washing.
For the correct operation of the water softener, the periodical
regeneration of the resins, whose frequency depends on the
number of washing cycles and water hardness, must be
carried out.
The relevant water supply company will be able to provide all
the instructions regarding the water hardness.
To Next Page
Loading...
