8.3 Temp.
When you select a washing programme, the
appliance automatically proposes a default
temperature.
The indicator Cold
= cold water.
The indicator of the set temperature comes
on.
8.4 Spin
When you set a programme, the appliance
automatically sets the maximum spin speed
allowed except programme Denim.
Additional spin options:
• No Spin
. The related indicator comes
on.
Set this option to deactivate all spin
phases. The appliance performs only the
draining phase of the selected washing
programme. Set this option for very
delicate fabrics. The rinse phase uses
more water for some washing
programmes
• Rinse Hold . The related indicator
comes on.
The final spin is not performed. The water
of the last rinse is not drained out to
prevent the fabrics from creasing. The
washing programme ends with water in
the drum.
The door stays locked and the drum turns
regularly to reduce creasing. You must
drain the water to unlock the door.
If you touch the Start/Pause button, the
appliance performs the spinning phase
and drains the water.
• Night . The related indicator comes
on.
The intermediate and the final spinning
phases are suppressed and the
programme ends with water in the drum.
This helps to reduce creasing. The door
stays locked. The drum turns regularly to
reduce creasing. You must drain the water
to unlock the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available. In
some programmes the rinses are
performed with more water.
If you touch the Start/Pause button, the
appliance performs only the draining
phase.
The appliance empties the water out
automatically after approximately 18
hours.
8.5 Prewash
With this option you can add a prewash
phase to a washing programme.
The relevant indicator illuminates.
• Use this option to add a pre-wash phase
at 30 °C before the washing phase.
This option is recommended for heavily
soiled laundry, especially if containing
sand, dust, mud and other solid particles.
These options can increase the
programme duration.
8.6 Permanent Extra Rinse
With this option you can add a few rinses
according to the selected washing
programme.
Use this option for people with allergies to
detergent residues and with sensitive skin.
This option increases the programme
duration.
The corresponding indicator above the touch
button illuminates and also stays permanently
on during next cycles until this option is
deactivated.
8.7 Permanent Soft Plus
Set this option to optimise the fabric softener
distribution and improve fabric softness.
Recommended when you use fabric softener.
This option increases the programme
duration.
ENGLISH 15
To Next Page
Loading...
