Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button repeatedly
until the display shows and the
indicator
goes off.
3. Touch the Start/Pause button again to
start the programme immediately.
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Start/Pause
button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button repeatedly
until the display shows the desired delay
time.
3. Touch the Start/Pause button again to
start the new countdown.
12.8 The SensiCare System load
detection
The programme duration in the display is
referred to a medium/high load.
After touching the Start/Pause button, the
SensiCare System starts the laundry load
detection:
1. The appliance detects the load in the first
30 seconds. In the programmes where
Time Manager is available, during this
phase the Time Manager bars
placed below the time digits play a simple
animation. The drum rotates shortly.
2. The programme duration could be
adjusted accordingly and could increase
or decrease. After further 30 seconds, the
water filling starts.
About 20 minutes after the programme
start, the programme duration could be
adjusted again depending on the
capacity of water absorption of the
fabrics.
The SensiCare detection is carried out
with complete washing programmes only
and if the programme duration has not
been reduced.
The SensiCare System is not available
with all programmes such as :Wool,
Rinse, Spin and programmes with short
cycles.
12.9 Interrupting a programme and
changing the options
When the programme is running, you can
change only some options:
1. Touch the Start/Pause button.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the Start/Pause button again.
The washing programme continues.
To start the programme again make sure
that the programme dial is correctly
positioned on the interrupted programme
and the indicator of the Start/Pause
button is flashing.
12.10 Cancelling a running
programme
1. Press the button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press the button On/Off again to activate
the appliance.
24 ENGLISH
To Next Page
Loading...
