Manager bars placed below the
time digits play a simple animation.
2. After about 15-20 minutes the Time
Manager bars disappear and new
cycle duration is displayed.
The appliance automatically adjusts
the programme duration to the load
to achieve perfect washing results in
the minimum possible time.
11.9 Interrupting a programme
and changing the options
When the programme is running, you
can change only some options:
1. Touch the button Start/Pause
.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the button Start/Pause
again.
The washing programme continues.
11.10 Cancelling a running
programme
1. Press the button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press the button On/Off again to
activate the appliance.
If the SensiCare System has
completed and the water
filling has already started,
the new programme starts
without repeating the
SensiCare System. The
water and the detergent are
not drained out in order to
avoid waste.
There is also an alternative way of
cancelling:
1. Rotate the selector knob to the "Reset"
position .
2. Wait for 1 second. The display shows
.
Now, you can set a new washing
programme.
11.11 Opening the door -
Adding garments
If the temperature and level
of the water in the drum are
too high and/or the drum is
still rotating you should not
open the door.
While a programme or the delay start
operates, the appliance door is locked.
The display shows the indicator .
1. Touch the Start/Pause button.
The indicator starts flashing.
2. Wait until the door lock indicator
stops flashing and goes off. Open the
appliance door. If necessary, add or
remove the items. Close the door
and touch the Start/Pause
button. The programme or the delay
start continues.
11.12 End of the programme
When the programme has finished, the
appliance stops automatically. The
acoustic signals operate (if they are
active). The display shows
The door unlocks and the indicator
goes off.
1. Remove the laundry from the
appliance.
2. Make sure that the drum is empty.
3. Keep the door and the detergent
dispenser slightly ajar to prevent
mildew and odours.
11.13 Draining water out after
end of cycle
If you have chosen a programme or an
option that does not empty out the water
of the last rinse, the programme is
completed, but:
• The time area shows
and the
display shows the door locked
.
• The drum still turns at regular
intervals to prevent creases in the
laundry.
• The door stays locked.
www.electrolux.com22
To Next Page