The SensiCare detection is
carried out with complete
washing programmes only
and if the programme
duration has not been
reduced by means of the
Time Manager button.
The SensiCare System is
not available with all
programmes such as :Lana/
Lãs, Aclarado/Enxag. and
programmes with short
cycles.
11.9 Interrupting a programme
and changing the options
When the programme is running, you
can change only some options:
1. Touch the Inicio/Pausa
button.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the Inicio/Pausa button
again.
The washing programme continues.
To start the programme
again make sure that the
programme dial is correctly
positioned on the interrupted
programme and the indicator
of the Inicio/Pausa
button is flashing.
11.10 Cancelling a running
programme
1. Press the button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press the button On/Off again to
activate the appliance.
If the SensiCare System has
completed and the water
filling has already started,
the new programme starts
without repeating the
SensiCare System. The
water and the detergent are
not drained out in order to
avoid waste. The display
shows the maximum
duration of the programme,
updating it about 20 minutes
after the starting of the new
programme.
There is also an alternative way of
cancelling:
1. Rotate the selector knob to the "Reset"
position .
2. Wait for 1 second. The display shows
.
Now, you can set a new washing
programme.
11.11 Opening the door -
Adding garments
If the temperature and level
of the water in the drum are
too high and/or the drum is
still rotating you should not
open the door.
While a programme or the delay start
operates, the appliance door is locked.
The display shows the indicator
.
1. Touch the Inicio/Pausa
button.
In the display the related door lock
indicator goes off.
2. Open the appliance door. If
necessary, add or remove the items.
Close the door and touch the Inicio/
Pausa
button.
www.electrolux.com26