36 electrolux use
pilot light (Door) is on, the
Start/Pause light is off and the door is
blocked to indicate that the water must
be emptied out.
To empty out the water:
turn the programme selector dial to “O”
select the (Drain), (Spin) programme
reduce the spin speed if needed, by
means of the relevant button
depress Start/Pause button
Select the Prewash (Prelavado)
option
Select this option if you wish
your laundry to be
prewashed at 30ºC before
the main wash.
The prewash ends with a
short spin in programmes for
Cotton and Synthetic fabrics, whereas
in the programmes for Delicates fabrics
the water is only drained.
Select the AquaCare option
This button can be
selected with all
programmes except the
wool and hand wash
programmes. The
machine performs some
additional rinses.
This option is recommended for people
who are allergic to detergents, and in
areas where the water is very soft.
Display
The display shows the following
information:
Duration of the selected programme
After selecting a programme, the
duration is displayed in hours and
minutes (for example 2.05).
The duration is calculated automatically
on the basis of the maximum
recommended load for each type of
fabric.
After the programme has started, the
time remaining is updated every minute.
Incorrect option selection
If an option which is not compatible with
the set wash programme is selected,
the message Err is displayed for about
2 seconds and the integrated red
Start/Pause light start flashing.
Alarm codes
In the event of operating problems,
some alarm codes can be displayed, for
example E20 (see paragraph “Something
not working”).
End of programme
When the programme has finished a
flashing zero is displayed.
Heating phase
During the washing cycle the display
shows a temperature icon to indicate
that the appliance has started the
heating phase of the water in the tub.
To Next Page
Loading...
