Problem Possible cause Solution
The room temperature is
too high.
Refer to "Installation" chap‐
ter.
The door is opened too
often.
Do not keep the door open
longer than necessary.
The door is not closed
correctly.
Refer to "Closing the door"
section.
The light does not work. The appliance is not
plugged in.
Connect the appliance.
The circuit breaker trip‐
ped or a blown fuse.
Turn on the circuit breaker or
change the fuse.
The lamp is defective. Contact the service.
The light button is not op‐
erating.
Contact the service.
Too much vibration. The appliance is not sup‐
ported properly.
Check if the appliance
stands stable.
The appliance is noisy. The appliance is not sup‐
ported properly.
Check if the appliance
stands stable.
Water flows on the rear
plate of the appliance.
During the automatic de‐
frosting process, frost
melts on the rear plate.
This is correct.
Water flows inside the
wine cabinet.
Products prevent that
water flows into the water
collector.
Make sure that products do
not touch the rear plate.
The temperature in the
wine cabinet is too low or
too high.
The temperature regula‐
tor is not set correctly.
Set a higher or lower tem‐
perature.
The door is not closed
correctly.
Refer to "Closing the door"
section.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
9.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
9.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
www.electrolux.com14
To Next Page
Loading...
