FAULT CODES
If the display reads "AS" or "ES" , a sensor
has failed. Contact your Authorized Service
Center.
REMOVING COLLECTED WATER
1. Emptying the Bucket:
– When the bucket is full, the unit will
shut down and the BUCKET FULL
indicator will illuminate.
– Do not move the unit at this time oth-
erwise water may spill on the floor.
– Press sides of bucket gently to unclip
the bucket from the unit.
– Remove the bucket as shown in the
photographs below and empty the
bucket.
– Replace the empty bucket back into
the unit and once seated correctly,
the unit will start up again.
– You should hear a click when the
bucket is in the correct position
Warning! Discard water from bucket.
Water is not potable and cannot be
used for drinking.
6 electrolux
To Next Page
Loading...
