urface Cookin
SURFACECOOKINGUTENSILS
I I [] [] [] [] [] []
Pans should have flat bottoms.
Check for flatness by rotating a
ruler across the bottom. There
should be no gaps between the
pan and ruler.
* Specialty pans such as
lobster pots, griddles and
pressure cookers may be
used but must conform to the
above recommended cookware
requirements.
[] [] [] [] [] [] [] [] []
*GOOD
• Flat bottom and straight sides.
• Tight fitting lids.
• Weight of handle does not tilt pan.
Pan is well balanced.
• Pan sizes match the amount of
food to be prepared and the size of
burner.
• Made of material that conducts
heat well.
• Easy to clean.
[] [] [] [] []
POOR
• Curved and warped pan bottoms.
• Pan overhangs unit by more than
2.5 cm (1").
• Heavy handle tilts pan.
• Flame extends beyond unit.
Note: Always use a utensil for its intended purpose. Follow manufacturer's
instructions. Some utensils were not made to be used in the oven or on the
cooktop.
USING THEGRIDDLE
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Figure 2 Figure 3
Side with groove Flat Side
The griddle is intended for direct food cooking and can be used on both
sides (Figures 2 and 3). Do not use pans or other cookware on the
griddle. Doing so could damage the finish. With the grate in position over
the burner, set the griddle on top of the grate positioning the notches in
the griddle over the grate fingers (Figures 1 and 2).
Figure 1
To Next Page
Loading...
