Electrolux GAS COOKTOP - Usingthewok Stand

Surface Cookin
USINGTHE WOK STAND
[] I [] I [] I [] I I I I I [] [] I [] I I I [] I []
The Wok Stand provided with your cooktop is designed to allow round-bottomed woks to
be used. It is recommended that you use a 14 inch diameter (35.5 cm) or less Wok.
It is recommended that you use the right front POWER burner with the wok stand for best
performance. If properly positioned, the Wok Stand will not slide off the grate.
To Properly Position the Wok Stand:
With the grate in position over the burner, set the Wok Stand on top of the grate positioning
the notches in the Wok Stand over the cooktop grate fingers (See Figure 1).
Flat-bottom woks with large flat bottoms may also be used on
your cooktop Surface Burner Grates without the Wok Stand (See
Figure 2). Insure the stability of the flat-bottom wok before cooking
without the Wok Stand. If unstable, DO NOT use the flat-bottom
wok without the Wok Stand.
Round-bottom woks (with
a support ring) should NOT
be used (See Figure 3). The
supporting ring was not designed
for proper or stable use on the
Surface Burner Grates.
Proper use of flat-bottom wok
on Surface Burner Grate
Figure 2
Improper use of round-bottom wok
on Surface Burner Grate
Figure 3