Problem Possible cause Solution
Many food products were
put in at the same time.
Wait few hours and then
check the temperature
again.
The room temperature is
too high.
Refer to climate class chart
on the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool
to room temperature before
storing.
The door is not closed
correctly.
Refer to "Closing the door".
The "FastFreeze func‐
tion" or "FastCool func‐
tion" is switched on.
Refer to "FastFreeze func‐
tion" or "FastCool function".
There is too much frost
and ice.
The door is not closed
correctly or the gasket is
deformed/dirty.
Refer to "Closing the door".
Appliance is fully loaded
and it is set to the lowest
temperature
Set a higher temperature.
Refer to "Operation".
Temperature set in the
appliance is too low and
the ambient temperature
is too high.
Set a higher temperature.
Refer to "Operation"
Temperature is set incor‐
rectly.
Refer to "Operation" .
The compressor does not
start immediately after
pressing the "FastFreeze"
or "FastCool", or after
changing the temperature.
This is normal, no error
has occurred.
The compressor starts after
a period of time.
Water flows inside the re‐
frigerator.
Food products prevent
the water to flow into the
water collector.
Make sure that food prod‐
ucts do not touch the rear
plate.
The water outlet is clog‐
ged.
Clean the water outlet.
Water flows on the floor. The melting water outlet
is not connected to the
evaporative tray above
the compressor.
Attach the melting water out‐
let to the evaporative tray.
www.electrolux.com14
To Next Page
Loading...
