Problem Possible cause Solution
Door was not closed completely. Make sure the door is closed com‐
pletely.
Stored food was not wrapped. Wrap food in suitable packaging be‐
fore storing it in the appliance.
Water flows inside the refrigerator. Food products prevent the water
from flowing into the water collector.
Make sure that food products do not
touch the rear plate.
The water outlet is clogged. Clean the water outlet.
Water flows on the floor. The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
Attach the melting water outlet to
the evaporative tray.
Temperature cannot be set. The FastCool function is switched
on.
Switch off FastCool function man‐
ually, or wait until the function deac‐
tivates automatically to set the tem‐
perature. Refer to "FastCool func‐
tion" section.
The temperature in the appliance is
too low/too high.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door" section.
The food products' temperature is
too high.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Many food products are stored at
the same time.
Store less food products at the
same time.
The door has been opened often. Open the door only if necessary.
The FastCool function is switched
on.
Refer to "FastCool function" section.
There is no cold air circulation in the
appliance.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
"Hints and tips" chapter.
Temperature setting LEDs flash at
the same time.
An error has occurred in measuring
the temperature.
Contact the nearest Authorised
Service Centre. The cooling system
will continue to keep food products
cold, but temperature adjustment
will not be possible.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
installation instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
ENGLISH 15
To Next Page
Loading...
