Description
1. LED panel
2. Heating power light
3. Steam buttons button
4. Steam push button
5. Water tank
6. Fabric Brush
7. Lint brush
8. Nozzle
Before use:
Clean with a soft damp cloth.
During first uses a small smoke emission may occur, that’s normal.
Use
1. Filling water:
• Ensure appliance is unplugged, remove the water tank by
pushing tank release button
• Remove water inlet stopper to fill it with 300ml of water
Note: Your appliance was designed to operate using pure
demineralized water.
• Close the water inlet stopper
• Return the water tank to its place
Tips: Check the fabric’s label for recommendations.
• We recommended that you test acrylic, nylon or other synthetic
fabrics in an inconspicuous area to ensure these fabrics are not
damaged by hot steam
• As steam is very hot: never attempt to remove creases from
a garment while it is being worn, always hang garments on a
clothes hanger.
2. Hang your garment on a clothes hanger.
3. Plug-in the appliance, push the power on, the power light is
flashing. The appliance heat up. After 30s, the power light will be
lighting.
To Next Page
Loading...
