Electrolux Pump Espresso EES250 - Page 16

Electrolux Pump Espresso EES250 Operating Insruction
ENGLISH
Notice: Never use solvents, which could damage the plastic.
18. Do not immerse the appliance in water or other liquids.
19. Do not use the appliance outdoors.
●
Operation
Using the appliance for the rst time
1. Clean the machine thoroughly by operating the appliance 2-3 times with
the maximum capacity of fresh water but without coffee
2. When the appliance is rst used, the taste of espresso may inuenced by mixed
slight smell. It is normal and safe. The smell will disappear after the rst time
use.
How to Use
A. Fill the water tank
1. Please make sure the appliance is unplugged and turned off.
2. Remove the water tank and ll with clean water . (Capacity is 1.5L)
3. Fix the water tank back and make sure the cover is covered well.
B. Fill the lter
1. Hold the lter holder. Turn it left to the ▼mark and then remove the lter holder.
2. Place the single-cup or double-cup lter into the lter holder.
3. Use a measuring spoon to place one or two measures of ground coffee in the
lter. Then, use a coffee press to tamp down the coffee. Do not overll the lter.
Clean the rim of the lter to remove excess coffee before starting making
espresso.
4. Place the lter holder in its ange, lining the handle up with the arrow mark ▼.
Ensure that the lter holder is well-seated in the lter holder ange; then rotate
the handle to the right as far as possible till the holder is fully locked.