Problem Possible cause Solution
Temperature cannot be
set.
The Frostmatic function is
switched on.
Switch off Frostmatic func‐
tion manually, or wait until
the function deactivates
automatically to set the
temperature. Refer to
"Frostmatic function" sec‐
tion.
The temperature in the ap‐
pliance is too low/too high.
The temperature is not set
correctly.
Set a higher/lower temper‐
ature.
The door is not closed cor‐
rectly.
Refer to "Closing the door"
section.
The food products' temper‐
ature is too high.
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Many food products are
stored at the same time.
Store less food products at
the same time.
The thickness of the frost
is greater than 4-5 mm.
Defrost the appliance.
The door has been opened
often.
Open the door only if nec‐
essary.
The Frostmatic function is
switched on.
Refer to "Frostmatic func‐
tion" section.
There is no cold air circula‐
tion in the appliance.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and tips" chapter.
Some specific surfaces in‐
side the fridge compart‐
ment are warmer at some
times.
This is a normal state.
Temperature setting LEDs
flash at the same time.
An error has occurred in
measuring the tempera‐
ture.
Contact the nearest Au‐
thorised Service Centre.
The cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
ENGLISH 17
To Next Page
Loading...
