Electrolux W475S - Reset tare to zero

45
Procedure for use
Reset tare to zero
Press b once to high-
light ”RESET TARE TO
ZERO”.
Press SELECT.
This screen shows that the
stored tare parameter has
been cleared.
Press SELECT.
Reset tare to zero
If your attempt to clear the tare parameter fails at this
point, you will see an error message equivalent to:
“FAILED. PRESS SELECT” on the display. For trou-
bleshooting, see the section “Fault-finding, weighing
equipment” in the machine manual.
For machines with weighing equipment installed only!
SCALE ADJUSTMENTS
RESET TARE TO ZERO
DONE! PRESS SELECT
SELECT
SELECT
3588
4780
SERVICEPROGRAM
MAKE A CHOICE:
RESET SCALE TO ZERO
RESET TARE TO ZERO
TARE SCALE
SETTARETOACERTAINVALUE
READTAREVALUE
CALIBRATE THE SCALE
SELECT
RESET SCALE TO ZERO
RESET TARE TO ZERO
TARE SCALE
SETTARETOACERTAINVALUE
READTAREVALUE
CALIBRATE THE SCALE
ZERO CALIBRATION
READVERSIONNUMBER
EXIT
SELECT