To Next PageTo Next Page
Need help?Do you have a question about the Elektromaten TS 959 and is the answer not in the manual?
General| Type | Swing door operator |
|---|---|
| Frequency | 50 Hz |
| Opening angle | 110° |
| Power supply | 230V AC |
| Operating modes | Automatic, Manual |
| Safety features | Obstacle detection |
Defines intended use and safety practices for personnel.
Lists critical electrical, power, and environmental parameters.
Specifies suitable locations and conditions for control unit mounting.
Critical safety measures to prevent electrocution during electrical work.
Instructions for safe mains disconnection and required fuse ratings.
Cautions and recommendations for protecting components during wiring.
Visual representations of different mains supply connection types.
Steps for powering up and adjusting DES limit positions.
Step-by-step guide for setting limit positions using NES systems.
A sequence of steps for programming the control unit's functions.
Configuring force monitoring (DES) and travel time monitoring (NES).
Safety and handling advice for the X20 relay output.
Critical safety warning regarding the limitations of force monitoring.
Information on factory settings and recommended values for travel time monitoring.
Lists fault codes and corresponding troubleshooting steps.
