Need help?Do you have a question about the Elenberg FS-3010 and is the answer not in the manual?
Place the end cap onto the end of the cross base before proceeding with assembly.
Fasten the lower pipe to the cross base using a screw and cover with the base cover.
Slide the base cover along the lower pipe onto the cross base.
Pull out the extension pole and secure the stand pipe with screw A.
Firmly place the motor and switch box on top of the extension pole.
Complete assembly by attaching the guard and blade to the front of the motor.
Loosen screw A to adjust extension pole for height/direction, then retighten.
If the blade shakes, try repositioning it in another direction.
The protective grille covering the fan blades.
The rotating part that generates airflow.
The adjustable vertical pipe connecting the base to the motor unit.
Fastener used for securing the extension pole.
The decorative or protective casing for the lower pipe and base.
A finishing piece for the end of the cross base.
To Next Page
General