To Next PageTo Next PageHow to fix elero Remote Control when drive moves in wrong direction?
If your elero Remote Control drive moves in the wrong direction, it means the directions have been set incorrectly. To fix this, delete the transmitter and re-programme it correctly.
Why is the transmission control light flashing on my elero Remote Control?
If the transmission control light on your elero Remote Control is flashing, it indicates that the battery power is low. You should replace the batteries.
What to do if elero Remote Control drive is not functioning but transmission control light is illuminated?
If the drive of your elero Remote Control is not functioning, but the transmission control light is illuminated, it could be due to a couple of reasons: 1. The receiver might be out of the radio operating range. To solve this, move the receiver closer to ensure it is within the operating range. 2. The transmitter might not be programmed in the receiver. In this case, you will need to programme the transmitter.
Why is my elero monotel 28 201.0001 drive not working and the transmission control light is off?
If the drive of your elero Remote Control is not functioning and the transmission control light is not illuminated, the issue likely lies with the batteries. Here's what you can do: 1. The batteries may be empty. Replace them with new ones. 2. The batteries may be inserted incorrectly. Remove the batteries and re-insert them, making sure they are properly aligned.
General| Brand | elero |
|---|---|
| Model | monotel 28 201.0001 |
| Category | Remote Control |
| Language | English |
Always observe the following safety instructions for proper use and to avoid hazards.
Identifies the key buttons and components of the MonoTel handheld transmitter.
Describes the MonoTel handheld transmitter's function and user-friendliness.
Specifies that the MonoTel is intended solely for roller shutters/sun protection systems.
Instructions for mounting the transmitter's wall holder securely.
Explains the illumination and flashing behavior of the control light.
Describes how to operate one or more receivers simultaneously using group control.
Steps to program a transmitter to a receiver for the first time.
How to add more transmitters to an existing receiver setup.
Sets the lower intermediate position for roller shutters/awnings/blinds.
Sets the ventilation or reverse position for roller shutters/awnings/blinds.
Adjusts the previously set lower intermediate position.
Adjusts the previously set ventilation/reverse position for roller shutters/awnings.
Adjusts the previously set reverse position for venetian blinds.
Deletes the stored lower intermediate position.
Deletes the stored ventilation/reverse position.
Instructions to remove a single transmitter from the receiver's memory.
Instructions to erase all programmed transmitters from the receiver.
Steps for replacing the batteries in the transmitter.
Guidance on how to clean the transmitter device.
Common problems and their solutions for the transmitter.
