FILLING RESERVOIR
Before filling unplug from mains!
• Place the unit on a at, stable surface which must not be tilted more than 10° (see drawing)
• Fill the tank up to the marking with a good quality bubble uid .
• Switch the unit on via the On/O switch on the rear side.
• Switch the unit o after use and unplug it from the mains if it will notbe used for a long period of time.
• Rinse the unit regularly with clean water.
OPERATION
Once the reservoir has been filled Connect the power lead into smoke machine and earthed mains outlet . Then you can switch
the power on. By pressing the switch on the remote control, the machine start producing bubble .
Switch o when machine not used and unplug from mains if not use for long periods.
0
= OFF
I
= ON
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a tting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
ACCESSORIES
High quality bubble uid, specially designed for bubble machines guarantees a trouble -free use with a lot of bubbles.
10
10
10
10
PLEASE DON'T FILL OVER THE LINE!
1 Year Limited Warranty: Eliminator Lighting warranty is valid from the date of purchase. Our
1 year limited warranty covers manufacturing defects only. Serial number, place of purchase with
dated valid receipt must be submitted at time of service. Eliminator Lighting warranty does not cover
items or parts prone to wear and tear: lamps, fuses, brushes and belts. Eliminator Lighting warranty
is only valid with-in the United States.
WARRANTY
To Previous Page
Loading...