Elite Screens CineTension2 Series - Frequently Asked Questions (FAQ)

PRODUCT WHITE PAPER
http://www.elitescreens.com
10
Elite Screens Inc. |Elite Screens Europe GmbH| Elite Screens India |Elite Screens China Ltd.
Elite Screens Taiwan Corp |Elite Screens Japan |Elite Screens Australia
3-way Wall switch
3-prong power cable
Red: DC 12 +
Green: 0 V
-
RJ-45 input for 5-12V Trigger
IR “Eye” Receiver
UP
STOP
DOWN
Fig.1
IR/RF remote
Fig.2
Fig.3
5. 5-12 volt trigger (Item D, Fig 4): The built-in
5-
12V trigger input allows your screen to
synchronize its drop & rise with the projector’s
power cycle. The screen deploys when the
projector powers up and will retract when the
projector powers down. The 5-12 volt RJ45 cable
connects to your projector’s trigger output via a
separate cable that may or may not be provided by
the manufacturer of the projector. The trigger
feature will not work without an output cable from
the projector, but it can be tested by connecting the
Red (+) and Green (-) cable to a 9-volt battery.
Fig.4
1. IR remote control (Item A, Fig 1): The Infrared functions by direct line of
sight contact with a beam range of 30 feet. Aim the IR remote at the circular
window located on the left side of the screen
2. IR “Eye” Receiver (Item E, Fig 2): The IR “Eye” Receiver plugs directly into
the screen’s RJ-45 input to present a low profile line-of-sight control option for
your IR remote control even in a recessed ceiling installation.
3. RF Remote Control (Item B): The radio waves eliminate the need for a direct
line of sight with a range of 100 feet.
4. 3-Way Wall Switch (Item C, Fig 3): The 3-way wall switch is a wall mount
control box with an up/stop/down button and plugs directly into the screen’s
RJ-45 input.
6 ways to control your CineTension 2
5-12 Volt Trigger Cable