Smart ZB Thermostat 16 A
Rated power settings
The thermostat does not include any hardware to monitor the power output of the
heating load. To provide power monitoring functionality, the rated power value (W)
of the connected heating load needs to be entered in the app. You can view the
power consumption (W) on the app.
Rated power value
To monitor instant power value information in the app:
– Tap Rated Power Value
– On the pop-up menu enter the rated power value (A) and then tap Save (B).
Temperature Detection
Active Brightness Level
Screen Active Duration
Idle Brightness Level
Air Temperature
1 Min(s) 0 Sec(s)
100%
Screen Brightness Settings
Sensors Settings
Settings
Temperature Calibration
Rated Power Value
0 W
Rated Power Settings
?
Child Lock
Child Protection Settings
100%
? -9.0 C
Screen Brightness Settings
Child Protection Settings
SaveCancel
Rated Power Value
A
B
Child lock settings
The child lock helps to prevent children from operating the thermostat. When the
Child Lock is enabled, thermostat can be operated only using the app.
To enable/disable the child lock:
1. On the Home page, tap All devices > Thermostat.
2. Tap Settings.
3. Tap the toggle switch (A) to enable/disable the Child Lock settings.
Temperature Detection
Active Brightness Level
Screen Active Duration
Idle Brightness Level
Air Temperature
1 Min(s) 0 Sec(s)
100%
Screen Brightness Settings
Sensors Settings
Settings
Temperature Calibration
Child Lock
Child Protection Settings
100%
? -9.0 C
A
Valve Protection
Valve Protection Settings
NOTE: By enabling the child lock, thermostat can only be controlled using
the app and not change the temperature setpoint value using physical
device.
DUG_ZB Thermostat 16 A_ELKO-00 23
To Next Page
Loading...