Elko Smart ZB Thermostat 16 A - Using the Boost Mode

Smart ZB Thermostat 16 A
Using the boost mode
Using the boost mode, the setpoint is increased by 2 ºC from the current room
temperature setpoint.
To use the boost mode:
1. On the Home page, tap All devices > Thermostat.
2. On the device control panel page, tap .
3. In the slide-up menu, select the Boost Duration (A) and than tap Save.
NOTE:
• The boost duration is set to 1 hour by default.
• Changing setpoint using during boost mode will cancel boost mode
on the app
• The boost mode will stop automatically when the boost duration is
completed.
• If the current temperature is 28.5 ºC - 29.5 ºC (for P1–P6) or 38.5 ºC -
39.5 ºC (for P7–P8), then the boost mode will set the temperature to
the maximum temperature
4. To turn off the boost mode manually, go back to the control panel page and
tap .
5. In the slide-up menu, tap Off (B) and then tap Save.
Thermostat
30
Schedule
History
The Air Temperature setpoint ranger is 4 C~30 C.
Settings
Settings
Thermostat
The Air Temperature setpoint ranger is 4
C~30
C.
Cancel Save
Boost Duration
3 Hrs
2 Hrs
1 Hr
30 Mins
B
A
NOTE: By the end of the time counting down, the boost will be stopped
automatically. If the boost feature has been turned on, and in this period
there are one or more Schedule or Moment/Automation actions, the
system will stop the current Boost action immediately, and perform the
new actions (the new action always has a higher priority than the current
action).
DUG_ZB Thermostat 16 A_ELKO-00 29