Elko Smart ZB Thermostat 16 A - Removing the Device from ELKO System

Smart ZB Thermostat 16 A
Editing an automation
To edit an automation:
1. On the Automation tab, locate the automation you want to edit and tap
.
2. On the Edit page, you can tap each item (such as dimmer, shutter, delay,
temperature, etc.) to change the settings.
TIP:
• You can add one or more actions using .
• To delete an existing condition or action, slide each item towards left
and tap Delete.
Deleting an automation
To delete an automation:
1. On the Automation tab, locate the automation that you want to delete and
then tap
.
2. Tap Delete and tap Ok.
NOTE: After deleting an automation, the device action can no longer be
triggered.
Removing the device from ELKO system
You can remove a device from the device list using the ELKO Smart app.
NOTE: You can only remove the device by accessing the individual thermostat
control page. If it is not visible on the home page, you can enable it in the
group thermostat. Refer individual thermostat visibility, page 27.
To remove a device:
1. On the Home page, tap All devices and select the individual Smart ZB
Thermostat 16 A which needs to be removed.
2. Tap to display more details.
3. Tap Remove Device (A) and tap Confirm.
Smart ZB Thermostat 16A
More
Device information
Remove Device
Others
A
TIP: On the home page, you can tap and hold the individual Smart ZB
Thermostat 16 A to remove the device.
NOTE: Setting parameters will be retained when the thermostat is
removed from the ELKO system.
38 DUG_ZB Thermostat 16 A_ELKO-00