FCW installation (water
cooling system)
If the First Class you bought is
endowed with the water cooling
system, it is necessary to follow these
instructions.
On the machine front side (outlet side)
There are some water exit (left) and
entrance pipes (right) as shown in the
pic. f .
The quantity of water necessary for the
functioning can change according to
the product cooling phases, with
higher values when starting the slush
production and values that are close to
zero when you want to keep the slush.
We therefore recommend to connect
the machine to the water network with
the maximum capacity, thus the
pressure switch valve (pic. g) in the
machine will regulate the flux
according the real necessity.
Important:
It is not possible to connect the FCW
water entrance with the input of
another machine based on a water
cooling system (series).
It is not possible to connect several
machines based on the water cooling
system on the same outlet.
.
)
.
f.
. g)
..
:
a
).
.
Pressure switch refit
procedure
Warning! The following steps
must be performed by qualified
personnel.
When the pressure switch light, near
main switch in ON,
Pressure switch light
this indicates that the pressure switch
intervened to deactivate the
compressor. In order to refit this
device, it is important to follow the
instructions below:
1° Disconnect the power cable.
2° Push the pressure switch button
under the frame of the machine.
To Next Page
Loading...
Need help?
General
