ELMECO FCM Series User Manual

14
PROBLEM SOLVING GUIDE ELMECO SLUSH MACHINE MODEL FCM
P07 – Machine over freezes in COLD/DEFROST mode
Problem
Machine over freezes to the point that mixing augers are blocked by the amount of ice built-up
in the hopper
Reason_1
Thermostat probe (pos. 43) has been dislocated, is burned or conductive paste located
between probe and tank has been compromised
Solution_1
Remove the thermostat probe: remove 2 screws in the bracket holding the probe; once
bracket and spring being removed, gently pull down probe’s electrical wire down and take it
out. Clean the probe (or replace it) and the whole the probe goes into (pos. 42); reinstall the
new probe.

ELMECO FCM Series Specifications

General

Brand	ELMECO
Model	FCM Series
Category	Kitchen Appliances
Language	English