6
PROBLEM SOLVING GUIDE ELMECO SLUSH MACHINE MODEL FCM
Solution_2
Establish required space around the machine and reset the compressor by pressing down high
pressure switch (pos.93)
Reason_3
Condenser fan motor does not turn (pos.99).
Solution_3
Verify whether fan motor’s blades are not blocked by the condenser or a loose wire.
Verify whether fan motor is burned. If so, replace fan motor: 1. unplug the wires and remove
screws from the base of the machine (pos. 104); 2. Remove screw, which holds the fan motor
blades; 3. Install new fan motor and blade; 4. turn the machine back ON; 5. verify if fan motor
is turning and cooling the machine; 6. reset the high pressure switch (pos.93)
To Next Page
Loading...
Need help?
General
