VLAN Setting: You can set the VLAN setting in this page. There are two parts in this page. First one is to set
the packets related to the R7141-L1, and the second one is if you use the VLAN setting in the NAT Mode.
There are two kind of destination packets will come from the R7141-L1’s WAN port, one kind of packets
will go to the R7141-L1, the other will go through the LAN port to the PC.
VLAN Packets: if you enable the first VLAN Packets and set the VID, User Priority, then all the incoming
packets will be check with the IP Address and the VID.
Voice Vlan ID: You can follow your service provider to set your Voice Vlan ID.
Data Vlan ID: You can follow your service provider to set your Data Vlan ID.
User Priority: Defines user priority, giving eight (2^3) priority levels. IEEE 802.1P defines the operation for
these 3 user priority bits. Usually this will be defined by your service provider.
When you enable the first VLAN Packets and set the VID, User Priority, then all the incoming packets with
the TA’s IP address and the same VID will be accept by the TA. If the incoming packets with the TA’s IP
address but the different VID then the packets will be discard by the R7141-L1. The Other incoming
packets with different IP address will go through the LAN port to the PC.
To Next Page
Loading...