Eltel Networks Oy / Komentajankatu 5 / PL 50 02611 Espoo Finland
fax:+358 204114653 / www.safetyladder.fi
4.3 Compatibility
Make sure that this product is compatible with the other parts of your equipment. Check with instructions for every single piece of your
equipment. Climbing carriage No 932 CE is only compatible with the system containing safety rail B. Behind safety rail B you can see marking No
930 CE or No 931 CE or No 932 CE which means that safety rail is intended to be used only with climbing carriage No 932 CE.
4.4
Lean heavily backwards on the full body harness when climbing. Distance between the front edge of the profile and full body harness connection
point should be as short as possible. Do not add anything (damper or anything else) between the carriage and the full body harness. The carriage
will then move without obstruction. The hands are needed mainly for steering the climb.
4.5
If the dragging force acting on the carriage ceases – e.g. during a fall – the climbing carriage turns and locks onto the next recesse claw of the
profile at a maximum distance of 15 cm.
Instruction! The user should take special care during the last two meters before leaving the profile.
Warning! It is prohibited to do any changes, additions or refits to the climbing carriage without written permission of
the manufacturer.
Warning! Do not use the climbing carriage any other purpose than climbing.
Warning! Do not use the system under the influence of drugs or alcohol.
Warning! To avoid the worst possible situation take care that there are always at least two meters of free space under
the user.
5 MARKINGS
The climbing carriage shall be equipped with the following
appropriate markings:
- trade mark (Turvatikas® )
- UP arrow shows up when climbing
- CE0403 notified body No.
- load 40-120 kg
- EN 353-1 = standard applied
- No 932 CE = product number
- packaging date, for example 270309
- product’s serial number for example 09888
- notification to read through the Operation instructions
6 PLEASE OBSERVE
6.1 Rescue plan
A rescue plan must be prepared prior to each operation and feasible methods of rescue must be ready to put into action in case any problem with
the safety carriage shall arise during operation.
6.2
In use, the distance between the safety harness and carriage should be adjusted so that the leaning angle is as small as possible. However the
climber’s knees should not come into contact with the ladder rungs.
PRODUCT REGISTER
Model/type
No 932 CE
Serial number
Eltel Networks Oy
Komentajankatu 5 PL 50
www.safetyladder.fi
INSPECTION DATE AND COMMENTS REGARDING PRODUCT NO. 932 CE
signature
To Previous Page
Loading...