ELTEX NTU-RG-1402G-W - LAN Interface Indication; Reboot and Reset to Factory Settings; Delivery Package

____________________________________________________________________________________
____________________________________________________________________________________
NTU-2V, NTU-RG Optical Network Terminals 15
Wi-Fi
green
Wi-Fi is active
flashes
Wi-Fi data transfer
off
Wi-Fi is not active
PON
off
device booting
green
established connection between optical line terminal
and device
red
no signal from optical line terminal
Status
off
WAN interface is in static or bridge mode, PPP client
is not running
green
device was successfully authenticated on line
terminal (PPP session started in WAN interface)
orange
device is not authenticated (PPP session is not started
in WAN interface)
Power
off
device is disconnected from the power source or
faulty
green
current device configuration differs from the default
one
orange
default configuration is active
red
device booting
2.6.3 LAN Interface Indication
Table 10 lists operation modes indicated by LEDS for LAN ports on the device rear panel.
Table 10 – Light Indication of LAN Interfaces
Operation Mode
Yellow LED
Green LED
Port is in 1000Base-T mode, no data
transfer
solid on
solid on
Port is in 1000Base-T mode, data
transfer
solid on
flashes
Port is in 10/100Base-TX mode, no data
transfer
off
solid on
Port is in 10/100Base-TX mode, data
transfer
off
flashes
2.7 Reboot and Reset to Factory Settings
For device reboot, press the Reset button once on the device side panel. In order to reset the device to
factory settings, press the Reset button and gold it for 7-10 seconds until the POWER LED glows red. Factory
settings for IP address are: LAN – 192.168.1.1, subnet mask – 255.255.255.0. Access can be provided from LAN 1
and LAN 2 ports.
2.8 Delivery Package
The standard delivery package of NTU-2V, NTU-RG-1402G-W includes:
— NTU-2V, NTU-RG-1402G-W optical network terminal;
— 220V/12V power adapter;
— Operation Manual.